Design and Development of customized communication protocol for the serial link interface from PCI-E add-on card

Design and Development of customized communication protocol for the serial link interface from PCI-E add-on card

Design and Development of customized communication protocol for the serial link interface from PCI-E add-on card.

            D. Anandaraj, Rajalakshmy Sivaramakrishnan and G. Karun kumar

            ICTACT Journal on communication technology, ISSN: 0976-0091 December  2013, Volume 04, Issue: 04, Page no. 817-820.

 

Abstract


This paper describes the design and development of the communication protocol for the customized data communication switch (FloSwitch). This protocol concentrates on the serial link interface between PCI-e add-on cards and the FloSwitch in the parallel computing system. The serial link is an optical interconnectivity with a bit rate of 6.25Gbps in full duplex mode. The protocol receives data from the PCI-Express (PCI-e) add-on cards through the optical link at the FloSwitch and does the necessary processing on the data (example: floating point addition), and the result is transmitted through the optical link to the destinations. This task is performed according to the command field, other information available in the header and the data. This implementation is done on the Field Programmable Gate Array (FPGA).
Keywords:
FloSwitch, PCI-e Add-on Card, Optical Link, Floating Point


Last updated on : 15-11-2017 04:17:38pm